RGBlink
← 返回支持中心
proAV

系统集成与商业项目支持

查看支持范围

如问题涉及处理器控制、视频路由、安装设计、集成问题或 proAV 设备 OpenAPI，请从这里开始。

  • 商业安装、处理器、切换器、定标器和分发系统
  • proAV 设备 OpenAPI 控制问题
  • 已落地项目中的系统集成、部署和故障排查

开始支持对话

告诉我们您的设备型号和问题，或选择一个示例问题。

支持知识

从左侧目录选择文章后，在此查看完整内容。

FAQ / Q16pro / Save And Load Pages

Q16pro gen2 1U save and load pages

Overview

Q16pro Gen2 1U can store and recall up to 256 scenes, but the page workflow is not obvious if you only stay inside Layer view.

Applies to

Q16pro Gen2 1U

Prerequisites

  • Use firmware V1.42 or later on the processor.
  • Use XPOSE V2.0.7.7 or later.
  • Connect the PC and processor by network cable or serial cable.
  • If you use Ethernet, keep both devices in the same network segment. The factory default processor IP is 192.168.0.100.

Save a page

  1. Build the container in Display and create the scene layout in Layer.
  2. If you need more than the first 16 scenes, move into Scenes and open the settings control there.
  3. Use Page > Save Page to store the current layout.
  4. Return to Layer, build the next scene variation, then return to Scenes and save it to another page.
  5. Saved pages show as green in the interface.

Load a page

  1. Go to Scenes.
  2. Choose Page > Load Page.
  3. The active page shows red while saved but inactive pages remain green.

Switch scene on air

  1. Open Take Setting.
  2. Select the scene you want to switch.
  3. Click CUT to execute the switch.

References