RGBlink
← Back to Support Hub
proEvents

Support For Events & Broadcast Professionals

What we can help with

across live events, mobile production, broadcast operations, or for mixed proAV and streaming deployments.

  • Event, broadcast, rental, and production operations
  • Mixed workflows combining proAV processors with streaming gear
  • Rapid triage for show-critical or time-sensitive incidents

Start a support chat

Tell us your device model and what you need help with, or try a suggested question.

Support Knowledge

Select an article from the menu to view full content here.

General / mini Series / mini-pro v3 - Logo

Logo Overlay - mini-pro v3

Overview

Add a LOGO overlay to mini-pro outputs. Note that in enabling a LOGO, the LOGO is applied to all outputs, showing on both PST (Preview) and PGM (Program). LOGOs are typically small channel logos or branding logos to be positioned in the corner of a live video over other content. A LOGO is added to mini-pro using a laptop browser.

Applies to

mini-pro v3

Requirements

  • Firmware: minimum v1.5
  • Laptop: a laptop with browser app on the same network subnet as mini-pro

Logo Specifcations

  • Maximum size: 256*128
  • File Format: PNG or BMP

Configuration

  • Get the IP address of the mini-pro by pressing the "M" button on the front panel, tapping SETTINGS and entering the IP SETTING menu. In most environments the IP address will be "192.169.0.xxx"

  • Open a browser tab on a laptop (that is connected to the same network/LAN and enter the IP address of the mini-pro from above). The webApp for mini-pro will be loaded into the browser.

    If the RGBlink webApp does not open in the browser, check the Network settings of the laptop to ensure that both mini-pro and the laptop are on the same network subnet.

  • In the browser/webApp, click on LOGO then Show LOGO.

    • Click the "+" icon to add a LOGO and select the file from the laptop drive that is to be installed to mini-pro (noting requirements of Logo Specifications above)
    • If there is an existing LOGO use the bin icon to remove then add /install logo file from "+" icon.
    • Enter the X Y positioning values desired, and press the Enter to confirm.
    • Press Close LOGO, then show LOGO to enable/activate the logo on the mini-pro
    • Positioning of a LOGO once installed/available to mini-pro, can be adjusted on device
      • Press the "M" button , tap LOGO to enter the menu. Adjust LOGO position using the touchscreen or with the Joystick.

Display/Enable Logo

  • Press the "M" button , tap LOGO to enter the menu.
  • Use the on screen toggle to Enable/Disable LOGO

Reference

Guide: https://youtu.be/HEBBCgg4RGY